S5730-68C-PWR-SI-AC Specification | |
Fixed Ports | 48 x 10/100/1,000 Base-T, 4 x 10 Gig SFP+ |
PoE Supported | PoE+ Supported |
MAC Address Table | 32K MAC |
Dimensions (W x D x H) | 442 mm x 420 mm x 44.4 mm |
Slot | One extended slot that supports an interface card: 4 x 40 GE QSFP+ interface card |
Input Voltage | AC: Rated AC voltage: 100V to 240V; 50/60 Hz Max AC voltage: 90V to 264V; 47 Hz to 63 Hz |
DC: Rated DC power: -48V to -60V Max DC voltage: -36V to -72V | |
Maximum Power Consumption | Without card and PD: 68.3W Without card and full PoE load: 925W (switch power consumption: 185W, PoE: 740W) with AC 500W/DC 650W power supply |
Typical Power Consumption (without PD) Operating Temperature | Without card: 50.1W |
0m to 1,800m altitude: 0°C to 45°C (long-term); -5°C to 50°C (short-term) | |
Relative Humidity | 5% to 95% (non-condensing) |
Heat Dissipation | Heat dissipation using fans supporting intelligent speed adjustment |
Surge Protection | Surge protection capability of service ports: 7 kV |
MAC Address Table | IEEE 802.1d compliance |
32K MAC address entries | |
MAC address learning and aging | |
Static, dynamic, and blackhole MAC address entries | |
Packet filtering based on source MAC addresses | |
VLAN | 4094 VLANs |
Guest VLAN and voice VLAN | |
GVRP | |
MUX VLAN | |
VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports | |
1:1 and N:1 VLAN mapping | |
Reliability | RRPP ring topology and RRPP multi-instance |
Smart Link tree topology and Smart Link multi-instance, providing millisecond-level protection switchover | |
SEP | |
STP (IEEE 802.1d), RSTP (IEEE 802.1w), and MSTP (IEEE 802.1s) | |
ERPS (G.8032) | |
BPDU protection, root protection, and loop protection | |
IP Routing | Static route, RIPv1/v2, RIPng, OSPF, OSPFv3, ECMP, IS-IS, IS-ISv6, BGP, BGP4+, VRRP, and VRRP6 |
Multicast | PIM DM, PIM SM, and PIM SSM |
IGMP v1/v2/v3 and IGMP v1/v2/v3 snooping and IGMP fast leave | |
MLD v1/v2 and MLD v1/v2 snooping | |
Multicast forwarding in a VLAN and multicast replication between VLANs | |
Multicast load balancing among member ports of a trunk | |
Controllable multicast | |
Port-based multicast traffic statistics | |
IPv6 Features | Neighbor Discovery (ND) |
Path MTU (PMTU) | |
IPv6 ping, IPv6 tracert, and IPv6 Telnet | |
6to4 tunnel, ISATAP tunnel, and manually configured tunnel | |
ACLs based on the source IPv6 address, destination IPv6 address, Layer 4 ports, or protocol type | |
QoS/ACL | Rate limiting on packets sent and received by a port |
Packet redirection | |
Port-based traffic policing and two-rate three-color CAR | |
Eight queues on each port | |
WRR, DRR, SP, WRR + SP, and DRR + SP queue scheduling algorithms | |
Re-marking of the 802.1p priority and DSCP priority | |
Packet filtering at Layer 2 to Layer 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP port number, protocol type, and VLAN ID | |
Rate limiting in each queue and traffic shaping on ports | |
Security | Hierarchical user management and password protection |
DoS attack defense, ARP attack defense, and ICMP attack defense | |
Binding of the IP address, MAC address, port number, and VLAN ID | |
Port isolation, port security, and sticky MAC | |
MFF | |
Blackhole MAC address entries | |
Limit on the number of learned MAC addresses | |
IEEE 802.1x authentication and limit on the number of users on a port | |
AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC | |
SSH v2.0 | |
HTTPS | |
CPU defense | |
Blacklist and whitelist | |
IEEE 802.1x authentication, MAC address authentication, and Portal authentication | |
DHCPv4/v6 client/relay/server/snooping | |
Attack source tracing and punishment for IPv6 packets such as ND, DHCPv6, and MLD packets | |
SVF | Plug-and-play SVF client |
Automatic software and patch loading to clients | |
One-click and automatic delivery of service configurations | |
Independent client running | |
OAM | Software OAM |
EFM OAM | |
CFM OAM | |
Y.1731 performance test | |
Management and Maintenance | iStack (using service ports as stack ports) |
Virtual cable test | |
SNMP v1/v2c/v3 | |
RMON | |
Web-based NMS | |
System logs and alarms of different levels | |
802.3az EEE | |
sFlow | |
Intelligent O&M | |
Interoperability | Supports VBST (compatible with PVST/PVST+/RPVST) |
Supports LNP (similar to DTP) | |
Supports VCMP (similar to VTP) | |
Shenzhen Importgm Technology Co., Ltd.
Shenzhen Importgm Technology Co., Ltd. has been operating in the I T services market since 2010,focusing on the R&D, design and sales of core equipment and general accessories in the field of network communications, we are distributors and resellers of worldwide brands of communication equipment, general accessories and system solutions for global customers.We offer a wide range of products, including networking routers, switches, firewalls, servers, I P phones, video conferencing equipment, wireless A P, P D U and modules. We are located in Shenzhen with convenient transportation access. Over the years we have developed a team of highly skilled staff that delivers quality and effective solutions and services. Based on our rich experience, we can supply products with stable packages, reliable delivery, competitive prices and on-time support. Our products are exported to customers in such regions as the Middle East, Africa, America,Europe and Asia. We also welcome O E M and O D M orders.Whether selecting current products from our inventory or seeking engineering assistance for your project bid, you can consult our business staff at any time. Our service does not end when the invoice is printed but begins as soon as you have received your order. Any customers' business visit and negotiation is warmly welcomed. Let's work together and win-win together.
1. who are we?
We are based in Shenzhen,Guangdong, China, start from 2010,sell to Africa(15.00%),Mid East(15.00%),Southeast Asia(10.00%),Eastern Europe(10.00%),South America(9.00%),Northern Europe(5.00%),Central America(5.00%),Western Europe(5.00%),Domestic Market(5.00%),North America(5.00%),Oceania(5.00%),South Asia(3.00%),Southern Europe(3.00%),Eastern Asia(2.00%). There are total about 11-50 people in our office.
2. how can we guarantee quality?
Original brand new products; always pre-final Inspection before shipment;
3.what can you buy from us?
Switches, Routers, Firewalls, IP phones, Servers,Video Conference,AP, PDU,etc.
4. why should you buy from us not from other suppliers?
IMPORTGM has been operating in China for about 15 years. We are one of the largest and complete distributors and resellers of worldwide brands of communication equipment.
5. what services can we provide?
Accepted Delivery Terms: FOB,CFR,CIF,EXW,Express Delivery；
Accepted Payment Currency:USD,EUR,JPY,CAD,AUD,HKD,GBP,CNY,CHF;
Accepted Payment Type: T/T,L/C,MoneyGram,Credit Card,PayPal,Western Union,Cash,Escrow;
Language Spoken:English,Chinese,Spanish,Japanese,Portuguese,German,Arabic,French,Russian,etc.